Request a Quote
— Full-Scope Electrical Services

Every Repair. Every Panel. One Address.

Motor rewinding to VFD panel manufacturing—ten capabilities in-house, no outsourcing, no workarounds. Confirm your equipment is covered before you call.

/ Scope of Work

Capabilities Under One Roof

AC/DC Motor Rewinding & Repair

Alternator & Generator Repair

Specification-matched rewinding for AC and DC motors of all frame sizes. Tested under load before return. No substitute wire gauges or insulation grades.

Full alternator strip-down, bearing replacement, winding test, and load validation. Authorized Mecc Alte service procedures applied to every unit.

VFD Panel Manufacturing

Control Panel Manufacturing

In-house variable frequency drive panels built to plant load schedules. Each enclosure wired, labeled, and factory-tested before site dispatch.

MCC, APFC, and distribution panels fabricated in-house. Single-line diagrams supplied; as-built drawings delivered with every completed enclosure.

Pump Motor Repair

AVR Supply & Service

Automatic voltage regulator supply, replacement, and bench calibration for generator sets. Mecc Alte AVR units sourced directly through authorized channels.

Submersible and surface pump motors rewound and reassembled to original IP rating. Bearing housings checked and shaft run-out measured before seal-up.

Overhead shot of a completed VFD panel enclosure on an assembly bench, wiring looms neatly dressed and labeled, technician's hand visible at the bottom of frame, shop floor concrete visible around the panel
Overhead shot of a completed VFD panel enclosure on an assembly bench, wiring looms neatly dressed and labeled, technician's hand visible at the bottom of frame, shop floor concrete visible around the panel
+ In-House. Not Outsourced.

VFD Panels Built to Your Load Schedule

Off-the-shelf drives are sized for catalog loads, not your plant. Every VFD panel we manufacture starts from your motor list, your ambient conditions, and your shift pattern.

Single-point accountability from design through commissioning. One team, one address, no assembly-line handoffs between fabrication and installation.